Every component is plugged into the modular jack manifold on the end of the Power Supply using the cables supplied. There is no particular order in which these connections are made. All plugs and jacks are four conductor except for the one six conductor jack on the back of the Clerk’s Control Module.

Mount the Power Supply in the location you had designated on the Cable Length Diagram that you provided us.  All cables have been marked with their lengths for your convenience. Plug the cables for the Voting Modules into the Power Supply Manifold – any plug into any jack. Route the cables to each voting site and fix in place to the underside of the Dais where they will be out of harms way using the staples supplied. The small staple will accommodate 1 to 3 cables and the large staple will accommodate 4 to 7 cables. The last few feet of each cable must find its way to the working surface of the Dais. Our suggestion for this is to drill a 5/8" hole in the Dais at arm’s length from the front edge. A black plastic ferrule has been provided to line and trim this hole. Pass the cable through the ferrule and attach the Voting Module. When the Module is held about a foot in front of the voter’s face mark the cable where it passes through the ferrule. At a point about two inches past this mark attach a counter weight to the cable. Allow an equal amount of cable to hang free of the last point of attachment to the Dais. This will set up a retractable cable arrangement that keeps the cable from cluttering the desk surface.

Plug the cable into the end of a numbered Voting module at each location keeping in mind the position on the Display Panel you want each to occupy.

Now connect the Clerk’s Control Module and all Display Panels to the Power Supply jack manifold and the system is ready to use.