ELECTroVOTE

ELECTroVOTE™ 
Operating Instructions

First remove the small cover disk on the rear face of the Clerk’s Module and you will see a small lever switch. Lever Switch #1 (to the right) controls the "Lockout" feature. With the lever switch #1 in the up position (Lockout) no one can change their vote choice one the complete voting sequence has been displayed. Switch lever #2 and #3 are not to be disturbed and should be left in their down position.

The system is turned on at the Clerk’s Module.

Next the appropriate "absentee" switch in the left column is pressed for any voting member absent and the adjacent red LED will illuminate. The system is now ready for a voting sequence.

When a vote is requested, each voting member presses the switch on their Vote Module that represents their choice of "YES, "NO", or "ABS" (abstain). A green, red or yellow LED will illuminate as verification of their selection. Any vote can be changed by again pressing the vote switch of a new choice. However if the "Lockout" feature on the Clerk’s Module has been implemented, a vote change cannot be made once the voting has been displayed.

As each member present votes, the red LED in the left column on the Clerk’s Module will illuminate. When all these red LED’s are illuminated by virtue of having been voted or being absent, the Clerk presses the "Display" button and the total vote is simultaneously shown on all Display Panels. The system will refuse the "Display" request if the vote modules are not all represented by a vote choice or an absentee status.

Return to Top of Page