COMBO Description of Components Installation Operating Instructions Demonstration System Pricing How to Order Warranty Home

 SPEAK and VOTE COMBO™
Installation

SPEAKER REQUEST and VOTE MODULE

Your SPEAK and VOTE COMBO system was fully tested prior to shipment.  However, we suggest you satisfy yourself that there has been no damage during shipment.  It will take only five to ten minutes to lay all the components out on a table and connect them all together in the maner described below.

Mount the Power Supply in the location you had designated on the Cable Length Diagram that you provided us.  All cables have been marked with their lengths for your convenience.

Route the cables to each member's site and fix in place to the underside of the Dais where they will be out of harms way using the staples supplied. The small staple will accommodate 1 to 3 cables and the large staple will accommodate 4 to 7 cables. The last few feet of each cable must find its way to the working surface of the Dais. Our suggestion for this is to drill a 5/8" hole in the Dais at arm’s length from the front edge. A black plastic ferrule has been provided to line and trim this hole. Pass the cable through the ferrule and attach the Combo Module. When the Module is held about a foot in front of the member’s face mark the cable where it passes through the ferrule. At a point about two inches past this mark attach a counter weight to the cable. Allow an equal amount of cable to hang free of the last point of attachment to the Dais. This will set up a retractable cable arrangement that keeps the cable from cluttering the desk surface.

Plug the cable into the end of a numbered Combo Module at each location keeping in mind that the numeric seating position it will register on the Request Control module must be consistent with its location at the Dias you have selected for it.  Use the single row of jacks on the front of the Power Supply - ANY plug into ANY jack.

Next, plug the cable from the Request Control module into the single modular jack located on the upper row at the end of the Power Supply which has the 110 VAC socket.  Put the cables from the Clerk's Vote Control module, the Mayors Vote Module and all Vote Display Panels into the lower row of modular jacks at the same end.